Skip to main content

BMeters Hydroclima 2

Website

White BMeters Hydroclima 2 heat cost allocator with barcode, display, and button

Description​

HYDROCLIMA-2 is a heat cost allocator with dual temperature sensors and ambient temperature recording. It features wireless M-Bus communication, 10-year battery life, and provides up to 24 months of historical consumption and temperature statistics.

Configuration​

info

The device is delivered pre-configured, but it can be reprogrammed and customized through BMetering Software.

Configuration Procedure​

Programming and configuration of the device is carried out by radio, using an RFM-RX2 receiver and BMetering Software.

The BMetering software must be properly configured. Then trigger the configuration procedure with the allocator's button:

  • for the factory state of the allocator, press the button for < 1s
  • for the allocator already configured, press the button for > 5s, until the display shows the message “rF”.

The configuration of the allocator is described in the BMetering software user manual.

Wireless M-Bus Address Configuration​

Where to Find the Address on the Device​

The address is located above the barcode and below the display, as shown in the image below (8 digits).

Hydroclima 2 with the 8-digit wM-Bus address outlined next to the barcode above the display


Mapping the wM-Bus Address to CHESTER​

The mapping must be carried out using the CHESTER Terminal, for example with:


Managing and Adding wM-Bus Device Addresses in CHESTER​

Here you can manage the list of wM-Bus addresses (add/remove), adjust scan settings, and review example configurations for typical setups.


Message Encryption and Key Management​

The transmitted messages are encrypted.

The received data must therefore be decrypted, which is done using decryption keys.
To achieve this, there are two options: