Device behavior
This chapter explains what STICKER does in everyday situations and what you see when it happens. It describes STICKER firmware v2.0.0.
Device states
The status LED shows what the device is doing. Most flashes are very short and repeat every 3 s, so watch the device for a few seconds.
Normal operation
Startup
Lights red, yellow and green once, then joins the network.
once, about 3 s
Joining
Not on the network yet. Tries again after about 1 min, then with longer pauses, up to 1 h.
every 3 s
Connected
Everything works. Sends measurements every 15 min by default.
every 3 s
Weak signal
Still connected, but the network stopped answering. Tries a more robust data rate.
every 3 s
If the signal does not recover, the device joins the network again, about 4–5 h after the link was lost.
Other states
Radio off
Measures but sends nothing. Switch the radio on in HARDWARIO Manager.
every 3 s
Alarm active
A very short red flash, shown only in the Connected state.
every 3 s
Battery too low
Below 1.8 V at startup: blinks red for 5 s and switches off. Replace the batteries.
Calibration
Service test mode. Lasts 120 min, then the device restarts.
every second
A normal day
With the default settings, a connected STICKER:
- joins the network at startup and again after a lost connection;
- sends its measurements every 15 min;
- sends device information and its key settings after every join and once a day;
- checks the radio link with every 5th report;
- sets its clock from the network after the join and then once a week;
- sends an alarm report about 10 s after an alarm starts or ends.
Find the right page
| Situation | Page |
|---|---|
| The LED does something unexpected after you insert the batteries | Startup and initialization |
| The device does not appear in the network server, or data stopped arriving | Network connection |
| You want to know which messages to expect and how often | Messages and timing |
| You sent a command and nothing changed | Downlink processing |
| You need measurements from a period when the device was offline | History and counters |
| You want to set up alarms | Alarms |
| A 1-Wire probe was disconnected or replaced | 1-Wire probes |
| You change settings with a phone | Configuration |
| You have a question about the batteries | Battery and power |
| You decode the data in your own system | Payload and decoder |
| You need the firmware version or an update | Firmware versions and updates |
| You start from a problem you see | Troubleshooting |