📄️ Initial Configuration
After first powering up the device, connect to the device.
📄️ Configuration Reset
It may be desirable to reset the device's configuration to the default state. This can either be done by clicking the Factory Reset button in the System tab of the Web UI. This will reset the config and restart the device.
📄️ Device Discovery
If you set up the device to receieve it's IP address through DHCP, the assigned address will probably not be known to you. To find the device, you can listen for UDP broadcast packets on the port 53914. Every few seconds, the device will broadcast a packet with the following content:
📄️ Firmware Management
The device has remote over-the-air firmware update functionality. It can be be triggered by pressing the Upload Firmware button in the System section of the Web UI. After the firmware is uploaded, the device will reboot so the change can take place. You can verify the upload by checking the version and firmware name fields in the table in the Status tab.