Troubleshooting

1. Reboot the system

• sudo reboot: Initiates a system reboot using the command line.

• /system/reboot: Initiates a system reboot using MQTT broker

  tip

  You can read more about rebooting a system using MQTT here.

2. Restart the Device

1. Press the reset button on the back of the FIBER

2. Wait up to a minute.

3. Check Power Supply and Network Connectivity

If restarting the device via the button does not resolve the issue, please check the power supply:

1. Ensure that the power adapter is securely plugged into both the FIBER device and the power outlet.

2. Check the network cables to ensure they are securely connected to the FIBER device and the router.

3. If everything is working, then disconnect power to the FIBER device by turning it off.

4. Wait for a few minutes.

5. Turn on the FIBER device again and allow it some time to fully boot up.

4. Reinstall image and run the FIBER

1. Follow the installation instructions outlined in section Installation of this documentation.

2. Log in to the target

   ssh root@[ip address]

3. Run the installation script using the following command:

   /app/scripts/install.sh